You can find the results of your search below. If you didn't find what you were looking for, you can create or edit the page named after your query with the appropriate tool.


electronics:wr703n:unbricking: 3 Hits
keep your own and set it instead in minicom this way: setenv serverip printenv You s... 92 bytes) Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes Writing Err
linux:cnc: 2 Hits
o install linuxcnc on the third partition. By the way I had also to copy the iso file to this partition...|ref]]) By the way, you can transfer the file with this on the sourc
electronics:wr703n:relay: 2 Hits
onnection from to the device. This way I can have "non permanent" wifi internet at home ... '/etc/init.d/wifi_idle_shutdown enable''. By the way, the WR703N led is controlled like this: * alwa
electronics:wr703n:cgi: 2 Hits
nd less 403 Forbidden unexplained errors...) this way instead: $HTTP["url"] =~ "^/cgi" { cgi.assign = ( ".sh" => "/bin/sh" ) } This way, the server only allows CGI files to be run in an
electronics:wr703n:nohup: 2 Hits
t there are alternatives. ===== screen: the core way ===== It makes possible re-logging into the same... p?id=38846 ===== dtach: the smaller (and easier) way ===== opkg install dtach Start a detached ses
electronics:raspi:archlinux: 2 Hits
ile none swap defaults 0 0' >> /etc/fstab By the way, would be useful to remove the file access time i... ally get a correct console. Ouch my eyes. By the way, I enabled ''PubkeyAuthentication yes'' in ''/etc
electronics:wr703n:openwrt: 2 Hits
Use ''vi'' to edit ''/etc/config/network'' this way (eg.) <code> config interface 'loopback' ... ks Reciprocally, you should see your router this way (cabled network IP address): ping
wiki:welcome: 2 Hits
t that thrives through user contributions. A good way to stay informed on what's going on and to get us...|DokuWiki User Forum]] is an excellent way to get in contact with other DokuWiki users and i
electronics:raspi: 1 Hits
here for some reason... I would have done it this way: In /etc/fstab, add a 25MB ramdisk like this:
linux:cron: 1 Hits
of the variable" command, you could write it this way: <code bash> pids=$(pidof -x "$(basename $0)) [[
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki