Search

You can find the results of your search below. If you didn't find what you were looking for, you can create or edit the page named after your query with the appropriate tool.

Results

electronics:wr703n:openwrt: 6 Hits
mwares). ==== Accessing the WR703N for the first time: network configuration ==== The router is initia... DCAST RUNNING MULTICAST MTU:1500 Metric:1 This time my browser will see the router to be configured, ... round box 90%> Note (not really solved yet): Last time I tried it failed, and nothing was started. Runni... napshots/trunk/ar71xx/packages/Packages.gz. (...time goes by...) wget: bad address 'downloads.openwr
electronics:wr703n:unbricking: 4 Hits
u can save it as the default config, so that each time you start ''minicom'', you will get an automatic ... Hierarchical RCU implementation. NR_IRQS:128 plat_time_init: plat time init done Calibrating delay loop... 266.24 BogoMIPS (lpj=532480) Mount-cache hash table... +0000) multi-call binary This Board use 2.6.31 xt_time: kernel timezone is -0000 nf_conntrack version 0.
electronics:wr703n:relay: 3 Hits
links faster when going to die (2-minute shutdown time) * then off when the device is dead (obviously)... n # No SSH connection - slowly blink and count time led 0 sleep 1 elapsed=`expr $elapsed + 5... -gt "$delay_before_off" ]; then # After some time, check if wifi really was used rxnew=`wifi_rx
wiki:syntax: 3 Hits
1 Col 3 | ^ Heading 4 | no colspan this time | | ^ Heading 5 | Row 2 Col... Col 3 | ^ Heading 4 | no colspan this time | | ^ Heading 5 | Row 2 C... locks described in the previous section, but this time the name of the language syntax to be highlighted
electronics:raspi:archlinux: 3 Hits
umes you only have one ''dd'' running at the same time ;) One written, mount the card in your Raspberry... he way, would be useful to remove the file access time informations to reduce wear on the SD card (ie. n... _rsa.pub'' SSH key (had to type the password each time). ====== Display tweaks ====== ===== Video size
linux:cnc: 1 Hits
ade the kernel to something better suited to real time for controlling a CNC. Reboot. Install a CPU/Me
electronics:wr703n:cgi: 1 Hits
n enabled as it will suck your storage space with time. Check the configuration file (or use ''-p'' whi
linux:cron: 1 Hits
===== Using a cron job to start a process at boot time, or making sure it is alive ====== Cronjobs are
electronics:wr703n:sdcard: 1 Hits
unt the card, plug the card reader again but this time without opening the disk (if ''mount'' tells you
electronics:raspi:i2c: 1 Hits
g. [[http://nicegear.co.nz/blog/using-an-i2c-real-time-clock-rtc-with-a-raspberry-pi/|howto]] (I2C for P
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki