RMUD Delta - aka the Rostock Montpellier Upside Down

MARLIN configuration.h

http://richrap.blogspot.fr/2013/12/3dr-build-tutorial-part4-firmware.html

http://reprapandme.blogspot.fr/2013/12/the-basics.html

http://reprapandme.blogspot.fr/2014/02/first-tests-and-calibration.html

Changes to configuration.h (from the delta variant of course), see also http://e3d-online.com/E3D-v6-Assembly

PID_MAX 64 --> b/c of 24V ipo 12V
TEMP_SENSOR_0 5 --> Semitec 104GT2 thermistor

Manual checklist and gcodes

Install printrun: http://reprap.org/wiki/Printrun

Check the end-stops manually:

M119
// Calibrate bed plan orientation with 3 points.
// Works for cartesian and delta machines.

M700            : Set bed plan and height with measured points
M701 Z P[0,1,2] : Measure A,B,C points with probe height Z if declared
M702 Z          : Reset bed plan orientation, measured points and maximum positions, and probe height Z if declared

M702
G1 X0 Y0 Z100 F9000
G1 X0 Y50 Z35 F9000
G4 S20
M701 Z31.84 P0

M700

M303 to autotune your PID (or see Tom's tutorial)

rmud_rostock_delta.txt · Last modified: 2014/12/14 20:38 by jim
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki