Search

You can find the results of your search below. If you didn't find what you were looking for, you can create or edit the page named after your query with the appropriate tool.

Results

wiki:syntax: 9 Hits
g "Edit this page". If you want to try something, just use the [[playground:playground|playground]] page... created by using square brackets. You can either just give a [[pagename]] or use an additional [[pagena... created by using square brackets. You can either just give a [[pagename]] or use an additional [[page... Linking to a specific section is possible, too. Just add the section name behind a hash character as k
electronics:raspi:archlinux: 4 Hits
an update is compulsory. As for me I try to avoid just because I do not want to distribute the whole SD card, but just my addition (a script + binaries): pacman -Syv ... illing my eyes I could (barely) see that ''sshd'' just was not started indeed: netstat -tanp Showed me... e you have a small monitor, this works (my system just will not take ''/boot/config.txt'' into account c
electronics:wr703n:relay: 3 Hits
want this, opkg install luci-proto-relay Else just enable it in the ''/etc/config/wifi'' configurati... which makes it really annoying. Here the device just shuts down when not used after a while. Just power it on again to resume wifi browsing! Save the follo
electronics:wr703n:openwrt: 3 Hits
92.168.0.255 Mask:255.255.255.0 (...) Just type the following command: ifconfig eth0:0 192... easily with Luci (next chapter). What's needed is just a working LAN network for Luci to help you! ====... k ===== ==== As a server ==== As a service, you just can edit ''/etc/config/wifi'' and comment out the
electronics:wr703n:unbricking: 2 Hits
latile/cn.bin It should download to /tmp/cn.bin. Just erase it, as it was just a test. Now, back to minicom: * plug a network cable to your WR703N (you ne
wiki:welcome: 2 Hits
u might also want to use a sidebar. To create it, just edit the [[:sidebar]] page. Everything in that pa... o get in contact with other DokuWiki users and is just one of the many ways to get [[doku>faq:support|su
linux:cnc: 2 Hits
d about not finding the CDROM during the install. Just switch to busybox console (control-alt-f2) and us... stemload-plugin'' The latency from linuxcnc menu just does not run, I get nothing. Better run it in a c
electronics:wr703n:webcam: 1 Hits
video|GSPCA]], which is supported by OpenWRT :) I just did: opkg install kmod-video-gspca-sn9c20x And
electronics:transcend_wifi_sd: 1 Hits
ing) ===== To enable telnet logging to the card, just add the ''autorun.sh'' (with Unix line endings) t
linux:cron: 1 Hits
nd itself, making sure to ignore itself. In bash, just add this to the start of your script: <code bash
electronics:raspi: 1 Hits
his]] is the one that worked for me, as there are just too many of them): <code bash> cd /usr/local/src
electronics:wr703n:cgi: 1 Hits
'server.modules''. After the closing parenthesis, just add server.modules += ( "mod_cgi" ) Then, the
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 3.0 Unported
Recent changes RSS feed Donate Powered by PHP Valid XHTML 1.0 Valid CSS Driven by DokuWiki